Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

ipv6 nd ra-guard attach-policy

Applies the RA guard policy to a specific interface.

Syntax
ipv6 nd ra-guard attach-policy policy-name vlan {all | vlan-id-1, vlan-id-2...vlan-id-n | vlan-id1-vlan-idn}
Parameters
policy-name—Enter the RA guard policy name. A maximum of 140 characters.
Default
None
Command Mode
INTERFACE CONFIGURATION
Usage Information
NOTE: If you configure the BGP unnumbered feature on a VLAN, do not apply the RA guard policy for that VLAN.
  • This command is applicable for physical and port-channel interfaces.
  • You must associate the interface as a member port with the VLAN or VLANs that you specify in this command.
  • If you specify a VLAN ID that is not yet created in the system, the policy is applied when the VLAN is configured, becomes active, and is associated with this interface.
  • If you choose the all option:
    • The system applies the RA guard policy to all the VLANs that are associated with this interface.
    • The system applies the RA guard policy to any new VLANs that you associate with this interface in the future.
  • When you apply the RA guard policy to a primary VLAN, the primary VLAN works as a regular VLAN. The RA packets received on the promiscuous ports flood to all the member ports of the primary and secondary VLANs.
  • When you apply the policy to a secondary VLAN, the RA packets received on secondary ports are flooded to the member ports of the primary VLAN.
    NOTE: If the secondary ports are connected to host devices, ensure that you configure the device role as host using the device-role command.
Examples
OS10(conf-if-eth1/1/1)#ipv6 nd ra-guard attach-policy test vlan all
OS10(conf-if-eth1/1/1)#ipv6 nd ra-guard attach-policy test vlan 1,5
OS10(conf-if-eth1/1/1)#ipv6 nd ra-guard attach-policy test vlan 1-5
Supported Releases
10.5.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\