Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

ipv6 bgp unnumbered

Configures an interface to be a BGP auto-unnumbered interface.

Syntax
ipv6 bgp unnumbered {ebgp-template | ibgp-template}
Parameters
  • ebgp-template—Indicates to inherit an eBGP template for this auto-unnumbered interface using the inherit ebgp-template command. If there is no configuration under unnumbered-auto neighbor, the system does not inheit any templates from this neighbor.
  • ibgp-template—Indicates to inherit an iBGP template for this auto-unnumbered interface using the inherit ibgp-template command. If there is no configuration under the auto-unnumbered neighbor, the system does not inherit any templates from this neighbor.
Defaults
None
Command Modes
  • INTERFACE
  • INTERFACE-RANGE
Usage Information

Use the ipv6 bgp unnumbered command on interfaces that must be discovered as auto-unnumbered interfaces using RA messages.

Use this command on a Layer 3 interface.

You can use this command on the following interface types:

  • Physical interfaces
  • Port channel interfaces
  • VLAN interfaces
Example
OS10# configure terminal
OS10(config)# ipv6 nd max-ra-interval 4
OS10(config)# ipv6 nd min-ra-interval 3
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# no shutdown
OS10(conf-if-eth1/1/1)# no switchport
OS10(conf-if-eth1/1/1)# ipv6 nd send-ra
OS10(conf-if-eth1/1/1)#ipv6 bgp unnumbered ebgp-template
Supported Releases
10.5.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\