Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

ip route-import

Imports an IPv4 static route into a VRF instance from another VRF instance.

Syntax
[no] ip route-import route-target [route-map route-map-name]
Parameters
  • route-target—Enter the route-target of the nondefault VRF instance, from 1 to 65535.
  • route-map route-map-name—Enter the name of the route map to filter IPv4 routes imported from a VRF.
Default
Not configured
Command Mode
VRF CONFIG
Usage Information

You can import routes corresponding only to a nondefault or a default VRF instance. You cannot import routes that belong to a management VRF instance into another VRF instance.

To filter IPv4 routes imported from across VRFs, use a route map.

Use the no form of this command to remove the imported routes.

Example
OS10(conf-vrf)# ip route-import 1:1 ==> No route-map attached
OS10(conf-vrf)# ip route-import 1:1 route-map importOSPFBGProutes
Supported Releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\