Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

domain-id

Configures the domain-id for every vfabric.

Syntax
domain-id [preferred domain-id-val]
Parameters
  • domain-id—Enter the domain ID of the E_Port.
  • domain-id-val—Valid values are from 1 to 239.
Defaults
Dynamic Configuration
Command Mode
Vfabric CONFIGURATION
Usage Information
  • The configurations are supported only in the multiswitch mode. The configured domain ID can be preferred or dynamic.
  • If the domain ID is preferred, the switch requests preferred domain ID to the principal switch.
  • You can change the domain ID only when the vfabric is in an inactive state. To activate vfabric, add vlan and fcmap configuration under the vfabric configuration view. Ensure to configure the domain ID before configuring the vlan and fcmap in the vfabric configuration view.
  • When disruptive fabric reconfiguration (RCF) occurs, the switch transmits RDI request sequence with preferred domain ID. During nondisruptive reconfiguration (BF), the switch requests for previously allocated domain ID (previous runtime domain ID), if available. Otherwise, use the preferred domain ID.
  • The no form of this command resets to the default, dynamic value.
Example
OS10(conf-vfabric-<vfabric-id>)#domain-id preferred 2
Supported Releases
10.5.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\