Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

disable

Disables the port-security feature.

Syntax
[no] disable
The no disable command enables the port-security feature.
Parameters
None.
Default
Disabled. By default, the port-security feature is disabled on a physical or port channel interface.
Command Mode
INTERFACE-PORT-SECURITY
Security and access
sysadmin, netadmin, netoperator
Usage Information

The port-security feature is disabled by default on physical or port channel interfaces. In order to enable the port-security feature (for example, on port channel 1), run the following commands:

OS10#config terminal

OS10(config)#interface port-channel 1

OS10(config-if)#switchport port-security

OS10(config-if-port-sec)#no disable.

The no disable command enables the port-security feature and operates either with default or user-configured values. Following are the default values:

  • MAC learn-limit is 1.
  • The sticky feature is disabled.
  • MAC movement is disabled.

The default values are set only if the corresponding values are not configured. If you configure or provide these values before enabling port-security, all the user-configured values are retained even after enabling port-security.

The port-security feature functionality becomes active on a port only if the feature is enabled globally and on that particular port. Disabling this feature either at global level or per port renders this feature inactive on that port.

The following table describes the relationship between switch and port level port-security configuration:

Table 1. Relationship between switch and port level port-security configurationsRelationship between switch and port level port-security configurations.
Switch level port-security Port level port-security Effect
Enabled Disabled Disabled
Enabled Enabled Enabled
Disabled Disabled Disabled
Disabled Enabled Disabled
NOTE: When port-security becomes active on a port, all the MACs learned on that port are flushed if the mac-learning limit is not set to no-limit.
Example
OS10(config-if-port-sec)# no disable

OS10(config-if-port-sec)# disable
  
Supported Releases
10.5.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\