Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

destination

Configures a destination management device that receives streaming telemetry.

Syntax
destination {ip-address | domain-name} port-number
Parameters
  • ip-address — Enter the IPv4 or IPv6 address of the destination device. You can enter a fully qualified domain name (FQDN). The destination domain name resolves to an IP address — see System domain name and list.
  • domain-name — Enter the fully qualified domain name of the destination device. A maximum of 32 characters.

  • port-number — Enter the transport-service port number to which telemetry data is sent on the destination device.

Default
Not configured
Command mode
DESTINATION-GROUP
Usage information
When you associate a destination group with a subscription, telemetry data is sent to the IP address and port specified by the destination command. In the 10.4.3.0 release, only one destination is supported. The no version of this command removes the configured destination.
Example
OS10(conf-telemetry)# destination-group dest1
OS10(conf-telemetry-dg-dest1)# destination 10.11.56.204 40001
OS10(conf-telemetry-dg-dest1)# 
Supported releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\