Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

delay-restore-port timeout

Configures delay-restore port timer value.

Syntax
delay-restore-port timeout timeout-value
To remove configured timer value and return to default, enter the no delay-restore-port timeout command.
Parameters
  • timeout timeout-value - Enter the keyword timeout followed by the timeout value. The range is from 1 to 1200.
Default
90 seconds
Command Mode
CONFIGURATION MODE
Usage Information
This command is used to configure the global delay-restore-port timer value for non-VLT scenarios. This timer value is different from the delay-restore timer configuration under VLT domain. The ports where delay-restore-port is enabled are kept down after boot up for the specified number of seconds.
Example
OS10(config)# delay-restore-port timeout 100

OS10(config)# no delay-restore-port timeout

Supported Releases
10.5.2 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\