Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

delay-restore-port enable

Enables or disables delay-restore configuration at interface level.

Syntax
delay-restore-port enable
To disable the delay-restore configuration, enter the no delay-restore-port enable command.
Parameters
None.
Default
Disabled
Command Mode
INTERFACE CONFIGURATION MODE
Usage Information
Use the range command to enable delay-restore-port on all interfaces or a selected range of interfaces.
Example
ENABLE/DISABLE ON PHYSICAL INTERFACE:

OS10(config)# interface ethernet 1/1/1

OS10(conf-if-eth1/1/1)# delay-restore-port enable

OS10(conf-if-eth1/1/1)# show configuration

!

interface ethernet1/1/1

no shutdown

switchport access vlan 1

delay-restore-port enable

OS10(conf-if-eth1/1/1)# no delay-restore-port enable

 

ENABLE/DISABLE ON PORT-CHANNEL INTERFACE:

OS10(config)#interface port-channel 1

OS10(conf-if-po-1)# delay-restore-port enable

OS10(conf-if-po-1)# no delay-restore-port enable

 

ENABLE ON RANGE OF ETHERNET INTERFACES AND PORT-CHANNELS:

OS10(config)# interface range ethernet 1/1/1-1/1/10

OS10(conf-range-eth1/1/1-1/1/10)# delay-restore-port enable

OS10(config)# interface range port-channel 1-10

OS10(conf-range-po-1-10)# delay-restore-port enable
Supported Releases
10.5.2 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\