Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

Configure administrative distance for leaked routes

  1. Enter the VRF from which you want to leak routes in CONFIGURATION mode.
    ip vrf source-vrf-name
  2. Export all routes that belong to one VRF instance in VRF-CONFIGURATION mode.

    IPv4:

    ip route-export route-target route-map route-map-name

    IPv6:

    ipv6 route-export route-target route-map route-map-name
  3. Create a route-map.
    route-map rmap-name
  4. Change the administrative distance for leaked routes in ROUTE-MAP mode.
    set distance value
The following example shows configuration of administrative distance for routes that are exported from one VRF to another using a route-map:
OS10# configure terminal
OS10(config)# ip vrf vrf1
OS10(conf-vrf)# ipv6 route-export 1:1 route-map ExportOSPFBGProutes
OS10(conf-vrf)#exit
OS10(config)# route-map ExportOSPFBGProutes
OS10(config-route-map)# set distance 100

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\