Related Video
Private VLANs on SmartFabric OS10
This section describes how to configure a PVLAN domain.
OS10# configure terminal OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# private-vlan mode primary
OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# private-vlan mode promiscuous OS10(conf-if-eth1/1/1)# switchport mode trunk OS10(conf-if-eth1/1/1)# switchport trunk allowed vlan 10
OS10(config)# interface vlan 20
OS10(conf-if-vl-20)# private-vlan mode isolated
OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# switchport mode trunk OS10(conf-if-eth1/1/2)# private-vlan mode secondary-port
OS10(conf-if-eth1/1/2)# switchport trunk allowed vlan 20
OS10(config)# interface vlan 30
OS10(conf-if-vl-30)# private-vlan mode community
OS10(config)# interface ethernet 1/1/3 OS10(conf-if-eth1/1/3)# switchport mode trunk OS10(conf-if-eth1/1/3)# private-vlan mode secondary-port
OS10(conf-if-eth1/1/2)# switchport trunk allowed vlan 30
OS10# configure terminal OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# private-vlan mapping secondary-vlans 20, 30
OS10# show vlan private-vlan mapping Private Vlan: Primary : 10 Isolated : 20 Community : 30
OS10# show vlan private-vlan Primary Secondary Type Active Ports ------- --------- --------- ------ -------------------------------------------- 10 Primary Yes Eth1/1/1,1/1/5 20 Isolated Yes Eth1/1/2 30 Community Yes Eth1/1/3
OS10# show vlan Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs, @ – Attached to Virtual Network, P - Primary, C - Community, I - Isolated Q: A - Access (Untagged), T - Tagged NUM Status Description Q Ports * 1 Active A Eth1/1/4,1/1/6-1/1/32 P 10 Active A Eth1/1/1 T Eth1/1/5 I 20 Active T Eth1/1/2 C 30 Active A Eth1/1/3
Private VLANs on SmartFabric OS10