When the status of the logical unit becomes nominal, metro node automatically attempts to fail back the logical unit to its default controller. This is usually defined as the owner of the logical unit as determined by the array. The logical unit failover execution process is started again in order to optimize the performance on the storage array side. This failback occurs only if the array has the
autoswitch property enabled and the logical unit is visible through the controller.
NOTE:The
Simple Support Matrix for metro node provides more information on the supported Dell EMC storage systems and third-party arrays.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\