- Notes, cautions, and warnings
- Preface
- CLI Workspace and User Accounts
- Meta Volumes
- System Management
- About call-home notifications
- Additional documentation
- SupportAssist MFT feature
- Event log locations
- System Configuration log location
- Hardware acceleration with VAAI
- Offload copy overhead with XCOPY
- Renaming a metro node cluster
- LCD Front Panel settings
- Thin support in metro node
- Provisioning Storage
- Volume expansion
- Data migration
- About data migrations
- Migrating thin-capable storage
- About rebuilds
- One-time data migrations
- Batch migrations
- Prerequisites
- Creating a batch migration plan
- Checking a batch migration plan
- Modifying a batch migration file
- Starting a batch migration
- Pausing/resuming a batch migration (optional)
- Canceling a batch migration (optional)
- Monitoring a batch migration’s progress
- Viewing a batch migration’s status
- Committing a batch migration
- Cleaning a batch migration
- Removing batch migration records
- Configure the WAN Network
- Cluster Witness
- Consistency Groups
- Performance and Monitoring
- Metro node with active-passive storage arrays
Dell EMC Metro node 7.0.1 Administrator Guide
Configure the WAN Network
The two WAN ports on each metro node director support dual 10 Gigabit Ethernet inter-cluster links. The WAN ports are configured as part of the installation of a second cluster. This chapter describes the CLI contexts and procedures to change the configuration created during installation.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\