Polling (collection of the specified statistics) begins when the first sink is added to a monitor. Polling occurs automatically at the interval specified by the monitor’s
period attribute.
About this task
Use the
set command to change the polling period.
Use the
monitor collect command to run a collection immediately, before its defined polling interval.
Use the
set command to disable, or modify automatic polling for a monitor.
In the following example:
The
set command changes the period attribute to 0, disabling automatic polling
The
ll
command displays the change:
VPlexcli:/monitoring/directors/director-2-1-B/monitors/director-2-1-B_TestMonitor> set period 0
VPlexcli:/monitoring/directors/director-2-1-B/monitors/director-2-1-B_TestMonitor> ll
Attributes:
Name Value
--------------- --------------------------------------------------------------
average-period -
collecting-data false
firmware-id 4
idle-for 5.78min
ownership true
period 0s
.
.
.
To re-enable polling, use the
set command to change the period attribute to a non-zero value.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\