Install the wall-mount brackets. To attach the wall-mount brackets to the chassis, remove the outer six M4 6 mm screws that secure the bottom panel to the chassis, and then use the same screws to attach the brackets through the mounting holes as indicated by the red circles in the following figure.
Figure 1. Wall-mount bracket installation
Mount the device to a wall using the four keyhole openings indicated or the six mounting holes, all of which are shown in red. For best results, mount the device with the front I/O panel facing downward.
Figure 2. Keyhole openings and mounting holes
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\