Dell EMC DSS8440 Installation and Service Manual

Slide rail installation

Take out the inner member and slide the intermediate member back.
Figure 1. Removal of the inner member
Install the inner member into the chassis.
Figure 2. Installation of inner member into the chassis
Screw the outer member and bracket into the racket.
Figure 3. Installation of outer member into the rack
Insert the chassis to complete the installation.
1. Pull the middle rail fully extended in lock position, ensure ball bearing retainer is located at the front of the middle rail.
2. Insert the chassis into middle-outer rails.
3. When hit a stop, please push the release tab on middle rail.
4. Tighten chassis with shipping screws.
  Figure 4. Completion of installation
CAUTION Verify ball bearing retainer is locked forward.