Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC DSS8440 Installation and Service Manual

PDF

Installing the riser 2 module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.

Steps

  1. Open the PCIe bracket latch.
    Figure 1. Open the PCIe bracket latch
    This image shows how to open the PCIe bracket latch.
  2. Install the H730P+ card to the riser2 module.
    Figure 2. Installing the H730P+ card
    This image shows the installing of the H730P+ card.
  3. Close PCIe bracket latch.
  4. Press the riser2 module -edge down until the card is fully seated. Align the riser2 module connector with the card connector on the system board and push the riser2 module wards the connector to seat it firmly.
    Figure 3. Installing the riser 2 module
    This image shows the installing of riser 2 module.

Next steps

  1. Install the butterfly module.
  2. Install the top cover.
  3. Follow the procedure listed in After working inside your system

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\