- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Remove filler panels
- Install an ES40 shelf into the rack
- Install a DS60 shelf into the rack
- Install a DS600 shelf into the rack
- Install an FS25 shelf into the rack
- Connect Cables and Power On
- Connecting ES40 shelves
- DD9900 with ES40 cabling
- Connecting DS60 or DS600 shelves
- DD9900 with DS60 cabling with two SAS I/O modules
- DD9900 with DS600 cabling with two SAS I/O modules
- DD9900 with DS60 and DS600 cabling with three SAS I/O modules
- Connecting the HA interconnect
- Connecting data cables
- Connecting disk shelf power cables
- Routing the cables through the CMA
- Connecting controller power cables and powering on
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Run the configuration wizard
- Configuring the system with the configuration wizard
- Configure HA
- Add Storage Capacity