- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Remove filler panels
- Install an ES40 shelf into the rack
- Install a DS60 shelf into the rack
- Install a DS600 shelf into the rack
- Install an FS25 shelf into the rack
- Connect Cables and Power On
- Connecting ES40 shelves
- DD9900 with ES40 cabling
- Connecting DS60 or DS600 shelves
- DD9900 with DS60 cabling with two SAS I/O modules
- DD9900 with DS600 cabling with two SAS I/O modules
- DD9900 with DS60 and DS600 cabling with three SAS I/O modules
- Connecting the HA interconnect
- Connecting data cables
- Connecting disk shelf power cables
- Routing the cables through the CMA
- Connecting controller power cables and powering on
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Run the configuration wizard
- Configuring the system with the configuration wizard
- Configure HA
- Add Storage Capacity
PowerProtect DD9900 System Installation and Storage Expansion Guide
CIFS protocol
The CIFS Protocol settings section enables you to configure the CIFS protocol settings. Click Yes to configure the CIFS protocol settings, or click No to skip CIFS configuration.
The system uses the term MTree to describe directories. When you configure a directory path, DD OS creates an MTree where the data will reside.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\