- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Unpack the system
- Remove the accessories and rail mount kit from the shipping packages.
- Remove the controller and the bezels from the shipping packages.
NOTE For field installations, the controller has temporary handles pre-fitted at the factory to help in removal of the system from the box and for placing it in a rack. While the controller is being placed in a rack, the handles attached to the chassis can be removed by loosening the thumbscrew on each handle. The handles must be saved for future use.CAUTION Data Domain systems are heavy. Always use two people or a mechanical lift to move a system. The chassis displays warning labels.
Figure 1. Warning about lifting the system 
- Remove expansion shelves and their bezels from the shipping packages.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\