- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Third-party rack installation
Follow these best practice guidelines to ensure an orderly installation:
- Third-party racks might have PDUs which face into the rack. This can cause interference between the shelf and/or rear CMAs. Carefully plan and route cables to minimize any interference. It might be necessary to use a type of PDU that is mounted in the main rack area.
- The shelf rails have four adjustment ranges, 18-22", 22-26", 26-30", 30-34". The default length (out of the shipping crate) is the 22-26" setting.
- After installation, check each rail to ensure that it is level and in the correct location before installing the next rail.
- When securing rails to the NEMA channel, especially channels with square holes, install the screws loosely to prevent cross threading, and tighten by hand. Do not over torque.
- Use black M5 screws, which align with both round and square channel holes, to secure all rails and components in the customer racks. Discard all silver screws removed from the shipping rack.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\