Racks and rails
You can secure the 1U cable tray to
and non- racks that use a sliding rail system.
The rail kits are included in the cable tray packaging and are compatible with racks with the following types of holes:
- 3/8 inch square holes
- 9/32 inch round holes
- 10-32, 12-24, M5X.8, or M6X1 pre-threaded holes
The following table shows the hardware and the recommended rack types:
Hardware from kit
| Part Number and Description
| Recommended Rack Type
|
---|
![](https://dl.dell.com/content/guides/public/Html/dd_p_dd9800_install_guide/images/GUID-7A03629D-724D-4ADC-914F-45FC437A2F34-low.jpg) | 036-034-012
Custom Male-Female 8-32 x .75 screw
| Always used to secure rails, regardless of Rack Type
|
![](https://dl.dell.com/content/guides/public/Html/dd_p_dd9800_install_guide/images/GUID-B25F4254-59D3-4364-B286-5840A764929E-low.jpg) | 036-034-003
Custom square hole pin
| These replace the adaptors that come pre-installed in the rails. Used in racks that have .375" square hole mounting rails.
|
![](https://dl.dell.com/content/guides/public/Html/dd_p_dd9800_install_guide/images/GUID-72AE89B2-ACD9-4BE6-8F1D-0C30719FBC38-low.jpg) | 036-034-004
Custom threaded hole pin
| These replace the adaptors that come pre-installed in the rails. Used in racks that have threaded holes. These go into the threaded hole for support.
|
Rail kit mounting brackets adjust in length from 24 inches to 32 inches to accommodate different rack depths.