- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Installing the rails in the cabinet
About this task
NOTE The front edge of each rail is stamped L or R for left or right side, when the rail faces the cabinet front.
Install each rail in the cabinet.
Steps
- From the front of the cabinet, insert the rail alignment pins above and below the bottom U mark on the rear cabinet channel.
Figure 1. Holes for alignment pins 
- Pull the sliding rail to the front of the cabinet, and secure it to the front channel at the middle two holes of the rail using two of the provided screws.
- Secure the rail to the rear channel loosely with two screws to allow for adjustment when you install the enclosure.
Figure 2. Installing the rails 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\