- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Disconnecting cables for a shelf installed with the 1U cable management tray
When servicing a shelf installed with the 1U cable management tray, cables might need to be disconnected to perform servicing procedures.
Steps
- Unplug/disconnect all cables from the rear of the shelf to be serviced.
- Disconnect the cable guide clips from the chassis.
- Disconnect the cable guide clips from the 1U cable management tray.
- Move the cables out of the way to provide access for servicing the shelf.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\