- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Connect data cables on both nodes
NOTE The data cabling for both nodes of the HA pair must be identical.
- Enable data transfer Ethernet connectivity. Repeat for each connection.
- If using 1 Gb copper Ethernet, attach a Cat 5e or Cat 6 copper Ethernet cable to an RJ-45 Ethernet network port (start with ethMa and go up).
- If using 10 Gb copper Ethernet with an SFP+ connector, use a qualified SFP+ copper cable.
- If using 1/10 Gb fiber Ethernet, use MMF-850nm cables with LC duplex connectors.
- For 10GBaseT connections, use Cat6a S-STP Ethernet cables.
- Enable data transfer Fibre Channel (FC) connectivity. Repeat for each connection.
- Attach a Fibre Channel fiber optical cable (LC connector) to an I/O module port on the controller, and attach the other end (LC connector) to an FC switch or to an FC port on your server.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\