- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Add Storage Capacity
The system supports capacity expansion operations by adding new disks or disk shelves while the system is powered on. The chapter contained in this part provides overview information and instructions to verify the system health before adding storage to the system.
If the total capacity after the expansion will exceed 630 TB, complete the memory expansion as described in the Data Domain DD9500 and DD9800 Systems DIMM and Riser Card Replacement and Memory Upgrade and the cache SSD expansion described in this document.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\