The rack mounting kits are compatible with racks that have front-to-rear post spacing between 24 inches and 36 inches. The hardware fits the following types of mounting holes:
7.1 mm round holes
.375 inch / 9.2 mm square holes
M5, M6, 12-24, and 10-32 threaded holes
The controller rail kit includes the following items:
Two bracket assemblies, one marked for the left side and one marked for the right side of the rack
Figure 1. Rail bracket inside
1. Left inside bracket
2. Right inside bracket
Figure 2. Rail bracket outside
1. Left outside bracket
2. Right outside bracket
A cable management assembly (CMA), for organization of cables at the rear of the system, is already installed onto the
DD9800 system on a Data Domain rack. For field installed systems, the CMA is shipped with the
DD9800 system.
Figure 3. Cable management assembly (CMA)
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\