- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Run the configuration wizard
The CLI configuration wizard starts automatically the first time the system boots. The wizard prompts you through a series of questions that provide just enough information for initial system configuration and basic network connectivity.
NOTE You can initiate the CLI configuration wizard manually by entering the
config setup command.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\