- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
DS60 cable information
The primary and secondary nodes use the same cable type to connect to DS60 disk shelves.
| HD-mini-SAS connector on controller and enclosure | ||
|---|---|---|
| Cable model code | Part number | Cable length |
| XC-DS60-SAS-3M | 038-004-380-01 | 3 m (118 in) |
| XC-DS60-SAS-4M | 038-000-212-00 | 4 m (158 in) |
| XC-DS60-SAS-5M | 038-000-214-00 | 5 m (196 in) |
CAUTION Observe the following considerations when cabling new shelves:
- Work on one SAS loop at a time.
- Allow at least eight minutes between each cable removal or insertion on a SAS I/O module in the Data Domain controller to allow the Data Domain system to apply required firmware updates and device mapping on the DS60 shelf.
- Verify all SAS cables are fully seated at both ends.
- If possible, utilize available SAS I/O module connections to add new storage enclosures.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\