- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Connecting the expansion shelves and the controllers
Multiple expansion shelves are connected together and to the controller with qualified SAS cables.
NOTE You must save any extra SAS cables for future use.
The diagrams in the following sections show recommended cabling and component placement of a system and shelves in the rack(s). The cables that are provided support the controller and shelves in the rack positions as shown in the diagrams.
- Refer to the diagrams in the Connecting multiple ES30 shelves to the DD9800 system to connect a DD9800 system.
- Refer to the diagrams in the Connecting multiple DS60 shelves to the DD9800 system to connect a DD9800 system.
For more information about specific shelf cabling rules and guidelines for different types of shelves, see:
- Data Domain ES30 and FS15 Expansion Shelf Hardware Guide
- Data Domain DS60 Expansion Shelf Hardware Guide
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\