- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Connecting the expansion shelves and the controllers
- ES30 cable information
- Connecting multiple ES30 shelves to the DD9800 system
- DS60 cable information
- Connecting multiple DS60 shelves to the DD9800 system
- Connecting the HA interconnect
- Connect data cables on both nodes
- Power on the systems
- Install the bezel
- Configure System for Use
- Add Storage Capacity
Data Domain DD9800 System Installation and Storage Expansion Guide
Connecting the HA interconnect
About this task
NOTE
- The interconnect IP address is automatically configured with the IPv6 prefix d:d:d:d:d:/80
- If there is an IP conflict, set the registry key config.net.interconnect_ip6prefix.
Steps
- Refer to the diagram for the port connections.
Figure 1. DD9800 HA interconnect 
- Cable port 0 of the interconnect I/O module in node 0, slot 11 to port 0 of the interconnect I/O module in node 1, slot 11.
- Cable port 1 of the interconnect I/O module in node 0, slot 11 to port 1 of the interconnect I/O module in node 1, slot 11.
- Cable port 2 of the interconnect I/O module in node 0, slot 11 to port 2 of the interconnect I/O module in node 1, slot 11.
- Cable port 3 of the interconnect I/O module in node 0, slot 11 to port 3 of the interconnect I/O module in node 1, slot 11.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\