VTL Protocol Library page
The Library page enables you to configure the DD VTL protocol settings for a library.
To configure these settings outside of the configuration wizard, select
Table 1. Library page settings Library page settings
Item
Description
Library Name
Enter a name of from 1 to 32 alphanumeric characters.
Number of Drives
Number of supported tape drives.
Drive Model
Select the desired model from the drop-down list:
IBM-LTO-1
IBM-LTO-2
IBM-LTO-3
IBM-LTO-4
IBM-LTO-5 (default)
HP-LTO-3
HP-LTO-4
Number of Slots
Enter the number of slots per library:
Up to 32,000 slots per library
Up to 64,000 slots per system
This should be equal to, or greater than, the number of drives.
Number of CAPs
(Optional) Enter the number of cartridge access ports (CAPs):
Up to 100 CAPs per library
Up to 1000 CAPs per system
Changer Model Name
Select the desired model from the drop-down list:
L180 (default)
RESTORER-L180
TS3500
I2000
I6000
DDVTL
Starting Barcode
Enter the desired barcode for the first tape, in the format A990000LA.
Tape Capacity
(Optional) Enter the tape capacity. If not specified, the capacity is derived from the last character of the barcode.