- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Remove filler panels
- Install an ES40 shelf into the rack
- Install a DS60 shelf into the rack
- Install a DS600 shelf into the rack
- Install an FS25 shelf into the rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Run the configuration wizard
- Configuring the system with the configuration wizard
- Configure HA
- Add Storage Capacity
PowerProtect DD9400 System Installation and Storage Expansion Guide
Recommended rack locations for the system
Ensure that you install the system controllers and disk shelves in the appropriate rack locations.
NOTE: The following recommended rack locations support the cabling described in this document. Installing in other locations might require different cable lengths.
The following table lists the recommended locations for installing the system in the rack.
| Component | Configuration | Rack location |
|---|---|---|
| Controller location with DS60 or DS600 shelves | Single node or HA primary node | U12-U13 |
| HA standby node | U15-U16 | |
| FS25 location with DS60 or DS600 shelves | HA | U28-U29 |
| DS60 or DS600 locations | Single node or HA | U02-U11, U18-U27 |
| Component | Configuration | Rack location |
|---|---|---|
| Controller location with ES40 shelves | Single node or high-availability (HA) primary node | Rack 1: U13-U14 |
| HA standby node | Rack 1: U16-U17 | |
| FS25 location with ES40 shelves | HA | Rack 1: U40-U41 |
| ES40 locations | Single node or HA |
|
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\