Shows whether each interface is enabled (checkbox selected) or disabled (not selected). Click the checkbox to toggle the interface between the enabled and disabled states.
DHCP
Shows the current Dynamic Host Control Protocol (DHCP) configuration for each interface. Select
v4 for IPv4 DHCP connections,
v6 for IPv6 connections, or
no to disable DHCP.
IP Address
Specifies an IPv4 or IPv6 address for an interface on this system. To configure the IP address, you must set DHCP to
No.
Netmask
Specifies the network mask for this system. To configure the network mask, you must configure a static IP address and set DHCP to
No.
Link
Displays whether the Ethernet link is active (Yes) or not (No).
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\