- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Remove filler panels
- Install an ES40 shelf into the rack
- Install a DS60 shelf into the rack
- Install a DS600 shelf into the rack
- Install an FS25 shelf into the rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Run the configuration wizard
- Configuring the system with the configuration wizard
- Configure HA
- Add Storage Capacity
PowerProtect DD9400 System Installation and Storage Expansion Guide
Install a DS60 shelf into the rack
Complete the following steps to install a DS60 expansion shelf.
CAUTION:If the top of the shelf is installed above 32U high, a ladder is required to replace disk drives in DS60 shelves.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\