- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Remove filler panels
- Install an ES40 shelf into the rack
- Install a DS60 shelf into the rack
- Install a DS600 shelf into the rack
- Install an FS25 shelf into the rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Run the configuration wizard
- Configuring the system with the configuration wizard
- Configure HA
- Add Storage Capacity
PowerProtect DD9400 System Installation and Storage Expansion Guide
Identifying the rail kit components
This section describes the steps to identify the rail kit components.
The 2U sliding rail assemblies allow the server to be secured in the cabinet, and extended from the cabinet so that the system cover can be removed to access the internal FRUs.
- 1. Sliding rail (2)
- 2. Velcro strap (2)
- 3. Screw (4)
- 4. Washer (4)
The rails are compatible with racks with square holes, unthreaded round holes, and threaded round holes.
The rail kit also includes a unique cable management arm (CMA) bracket assembly that consists of inner and outer brackets, and screws to attach the brackets to the rails.
The CMA assembly consists of two articulated arms, and two separators.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\