- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Remove filler panels
- Install an ES40 shelf into the rack
- Install a DS60 shelf into the rack
- Install a DS600 shelf into the rack
- Install an FS25 shelf into the rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Run the configuration wizard
- Configuring the system with the configuration wizard
- Configure HA
- Add Storage Capacity
PowerProtect DD9400 System Installation and Storage Expansion Guide
DS600 rail mounting hardware
Factory-racked systems use only round hole racks, but field-racked systems support installation in round, square, or threaded hole racks.
The following mounting hardware comes in the rail kit:
| Identifier | Part | Quantity |
|---|---|---|
| A | M5x15(P0.8) | 2 |
| B | M6x12(P1.0) | 2 |
| C | #10-32x12 | 2 |
| D | #12-24x12 | 2 |
| E | M5x0.8 nut | 2 |
| F | M5x0.8 nut | 2 |
| G | M4x6(P0.7) | 6 |
| H | M5 (square) | 4 |
| I | M5 (circle) | 6 |
| J | M4x13(P0.7) | 2 |
The following hardware is required for each type of rack:
NOTE:If the quantity of a particular piece is not specified, all of that piece is required.
| Rack type | Required mounting hardware |
|---|---|
| Round hole | A, F, G, I |
| Square hole | A, E, G, H, I (x2) |
| Threaded hole | A or B or C or D (depending on rack thread type), G, I (x2), J |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\