This installation guide provides instructions for installing the hardware associated with PowerProtect systems. Systems are shipped to the customer site
either pre-installed in a rack (factory-racked) or
as separate components to install in an existing rack at the site (field-installed).
This guide provides instructions for both types of installation.
This document is intended for customers or Dell EMC Support personnel who are qualified to install PowerProtect systems.
Field-installed systems
To install PowerProtect systems in an existing rack at the customer site, follow all the instructions in this document to rack, cable, and configure the system.
Factory-racked systems
Factory-racked systems are pre-installed in the rack with the cables already connected. Follow the instructions in
Configure System for Use to configure factory-racked systems.
The following documents, available from the
Online Support website, provide additional information about factory-racked systems:
Dell EMC 40U-P Cabinet Site Preparation Guide
Dell EMC 40U-P Cabinet Unpacking and Setup Guide
Dell EMC Titan S Site Preparation Guide
Dell EMC Titan S Unpacking and Setup Guide
Dell EMC Data Domain Rack Service Guide
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\