- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Remove filler panels
- Install an ES40 shelf into the rack
- Install a DS60 shelf into the rack
- Install a DS600 shelf into the rack
- Install an FS25 shelf into the rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Run the configuration wizard
- Configuring the system with the configuration wizard
- Configure HA
- Add Storage Capacity
PowerProtect DD9400 System Installation and Storage Expansion Guide
Create File System page
The Create File System page displays the allowed size of each storage tier in the file system, and provides a setting to automatically enable the file system after it is created.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\