Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect DD9400 System Installation and Storage Expansion Guide

Connecting data cables

About this task

Slot numbers

The following figure shows the HBA slot numbers.

The slot labeled N is the network daughter card, which contains ports ethMa, ethMb, ethMc, and ethMd. The management port ethMa is the first port set up by the Configuration Wizard. It is marked with a red rectangle in the figure below.

Figure 1. Slot numbering
Slot numbering
Port numbers

The following port numbering guidelines apply to all HBAs except the network daughter card:

  • The physical interface name format for the remaining HBA slots is ethXy, where X is the slot number and y is an alphanumeric character. For example, eth5a.
  • The direction of the port numbering on an HBA depends on the slot location and the type of HBA. Check the labels on each HBA before connecting cables.
Slot assignments

The following table lists the slot assignments for the supported HBAs. The HBAs are listed in priority order.

Table 1. HBA slot assignmentsHBA slot assignments
Description Slot
16GB NVRAM,Full Height 2
SAS12,4P,FH
  • Required: 3, 7
  • Optional: 5
QAT,INTEL,8970,FH, Avnet p/n 1QA89701G1P5 4
FC16,TRG,QP,Full Height 5, 8, 1
2 Port, 25Gb SFP28 PCIe, Low Profile 6
2 Port, 25Gb SFP28 PCIe, Full Height 5, 8, 1
4 Port, 10GBASE-T PCIe, Low Profile 6
4 Port, 10GbE SFP+ PCIe, Full Height 5, 8, 1
4 Port, 10GBASE-T PCIe, Full Height 5, 8, 1

Steps

  1. For 10 GBASE-T connections, use one of the following:
    • Unshielded Cat 6 cables with RJ-45 connectors that do not exceed 55m
    • Cat 6A cables with RJ-45 connectors that do not exceed 100m
  2. For 10 GbE-SFP+ optical connections, refer to the list of qualified adapters and use an OM1 160 MHz (2 to 26m), OM1 200 MHz (2 to 33m), OM2 400 MHz, (2 to 66m), OM2 500 MHz (2 to 82m), OM3 1500 MHz (2 to 300m), or OM 4 3500 MHz (2 to 400m) SFP+ optical cable.
  3. For 25 GbE-SFP28 connections, use optical cables that support the 25GBASE-SR standard to connect to the 25 GbE-SFP28 optical transceivers.
  4. For FC connections, use a qualified OM1, OM2, or OM3 Fibre Channel optical cable:
    Table 2. Maximum FC cable lengthsMaximum FC cable lengths
    Data rate OM1 maximum length OM2 maximum length OM3 maximum length
    4 Gbps 70m 150m 380m
    8 Gbps 21m 50m 150m
    16 Gbps 15m 35m 100m

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\