- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Remove filler panels
- Install an ES40 shelf into the rack
- Install a DS60 shelf into the rack
- Install a DS600 shelf into the rack
- Install an FS25 shelf into the rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Run the configuration wizard
- Configuring the system with the configuration wizard
- Configure HA
- Add Storage Capacity
PowerProtect DD9400 System Installation and Storage Expansion Guide
CIFS Protocol Authentication page
The Authentication page enables you to configure Active Directory and Workgroup for your system.
To configure these settings outside of the configuration wizard, select .
| Item | Description |
|---|---|
| Active Directory/Kerberos Authentication | Expand this panel to enable, disable, and configure Active Directory Kerberos authentication. |
| Workgroup Authentication | Expand this panel to configure Workgroup authentication. |
| LDAP Authentication | Expand this panel to configure LDAP authentication. |
| NIS Authentication | Expand this panel to configure NIS authentication. |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\