iDRAC provides the ability to disable the dedicated iDRAC Ethernet port and assign the iDRAC connection to share one of the network daughter card Ethernet ports. This step is optional.
CAUTION:Do not configure iDRAC to use network daughter card ports 3 and 4, as they are reserved for the HA interconnect.
Steps
Connect to the system serial console or connect KVM to the system.
Reboot the system.
During the system boot process, press
F2 to access the BIOS menu.
Select
iDRAC Settings.
Select
Network.
Under
Network Settings, change
NIC Selection from
Dedicated to one of the following values:
Table 1. iDRAC NIC to physical port mappingiDRAC NIC to physical port mapping
iDRAC NIC selection
Physical network port
LOM1 - [NIC Integrated 1-1-1]
Network daughter card port 1
LOM2 - [NIC Integrated 1-2-1]
Network daughter card port 2
LOM3 - [NIC Integrated 1-3-1]
Network daughter card port 3
LOM4 - [NIC Integrated 1-4-1]
Network daughter card port 4
Press
Esc to return to the previous menu.
Exit the BIOS menu and reboot the system to allow the change to take effect.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\