Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

PowerProtect DD9400 System Installation and Storage Expansion Guide

PDF

Connecting disk shelf power cables

Prerequisites

Each disk shelf has two power supplies. Connect each power supply to redundant AC power sources, so the loss of one power supply or one power source does not cause the shelf to power off.

About this task

FS25 shelves have one power cord per power supply for a total of two power cords.

DS60 shelves have two power cords per power supply for a total of four power cords.

Steps

  1. Plug the power cords into both power supplies on the disk shelf.
  2. If the disk shelf has a retention bail, secure the power cord with the retention bail. The bail prevents the power cord from pulling out of the connector.
  3. For ES40 shelves, connect each power cord to redundant power sources in the rack.
    Figure 1. ES40 single phase power cabling
    ES40 single phase power cabling
    Figure 2. ES40 three phase delta power cabling
    ES40 three phase delta power cabling
    Figure 3. ES40 three phase WYE power cabling
    ES40 three phase WYE power cabling
  4. For FS25 shelves, connect each power cord to redundant power sources in the rack.
    Figure 4. FS25 single phase power cabling
    FS25 single phase power cabling
    Figure 5. FS25 three phase delta power cabling
    FS25 three phase delta power cabling
    Figure 6. FS25 three phase WYE power cabling
    FS25 three phase WYE power cabling
  5. For DS60 shelves, connect each power supply to redundant power sources in the rack.
    Figure 7. DS60 single phase power cabling
    DS60 single phase power cabling
    Figure 8. DS60 three phase delta power cabling
    DS60 three phase delta power cabling
    Figure 9. DS60 three phase WYE power cabling
    DS60 three phase WYE power cabling
  6. For DS600 shelves, connect each power supply to redundant power sources in the rack.
    Figure 10. DS600 single phase power cabling
    DS600 single phase power cabling
    Figure 11. DS600 three phase delta power cabling
    DS600 three phase delta power cabling
    Figure 12. DS600 three phase WYE power cabling
    DS600 three phase WYE power cabling
  7. Repeat the preceding steps for each shelf in the rack.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\