Identify the designated location for the system controller or controllers in the rack.
When using systems with ES30 shelves:
The designated location for a single node, or the primary node of an HA pair is U13-U14 in rack 1.
The designated location for the standby node of an HA pair is U15-16 in rack 1.
When using systems with DS60 shelves:
The designated location for a single node, or the primary node of an HA pair is U22-U23 in rack 1.
The designated location for the standby node of an HA pair is U25-26 in rack 1.
NOTE The designated slots in the rack are the recommended location for the systems to support the cabling described in this document. Other locations may require different cable lengths for some configurations.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\