- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Add Storage Capacity
Data Domain DD9300 System Installation and Storage Expansion Guide
DD9300 (single node, DD Cloud Tier, or ERSO)
DD9300 systems support a maximum of 28 shelves, divided into four sets of seven shelves.
NOTE For configurations of 16 SAS shelves or less, do not exceed four shelves per set.
| String (Loop) | I/O - Port | Shelf Port | Length 1 |
|---|---|---|---|
| 1 | I/O 7 - Port 0 | B controller HOST
 port of shelf V1.1
| 2M |
| 1 | I/O 2 - Port 0 | A controller HOST
port of the highest number shelf in V1
| 2M |
| 2 | I/O 7 - Port 2 | B controller HOST
port of shelf V2.1
| 2M |
| 2 | I/O 2 - Port 2 | A controller HOST
port of the highest number shelf in V2
| 2M |
| 3 | I/O 7 - Port 1 | B controller HOST
port of shelf V3.1
| 2M |
| 3 | I/O 2 - Port 1 | A controller HOST
port of the highest number shelf in V3
| 2M |
| 4 | I/O 7 - Port 3 | B controller HOST
port of shelf V4.1
| 3M |
| 4 | I/O 2 - Port 3 | A controller HOST
port of the highest number shelf in V4
| 3M |
1 Cable lengths shown are designed for Data Domain racks. Longer cables (up to 5M) can be used.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\