- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Add Storage Capacity
Most installations would benefit from the configuration of a few additional system parameters, provided in this section for convenience.
# config set mailserver mail.datadomain.com The Mail (SMTP) server is: mail.datadomain.com
# config set location "Dallas Regional Data Center Lab, 5000 Apple Drive Suite #130, Dallas, Tx" The System Location is: Dallas Regional Data Center Lab, 5000 Apple Drive Suite #130, Dallas, Tx
# ntp add timeserver 192.168.101.1 Remote Time Servers: 192.168.10.1
# ntp enable NTP enabled.
# config set timezone US/Central The Timezone name is: US/Central *** You made a change to the timezone setting. To fully effect this change *** (in currently running processes), you need to reboot the machine.
# system reboot The 'system reboot' command reboots the system. File access is interrupted during the reboot. Are you sure? (yes|no|?) [no]: yes ok, proceeding. The system is going down for reboot.
# autosupport send your.email@emc.com OK: Message sent.