- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Accepting the End User License Agreement
- Run the configuration wizard
- Using the system configuration wizard
- License
- Network
- Passphrase
- File System
- Settings
- Selecting and configuring Secure Remote Services delivery
- Installation Troubleshooting
- Add Storage Capacity
PowerProtect DD6400 System Installation and Storage Expansion Guide
Network
The Network section is a read-only page that summarizes the general settings and configuration.
To make changes to the network settings after the Configuration Wizard is complete, select .
To avoid IP address conflicts with the DDOS-iDRAC interconnect, do not configure 169.254.0.<X> and 169.254.1.<X> IP addresses.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\