- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Accepting the End User License Agreement
- Run the configuration wizard
- Using the system configuration wizard
- License
- Network
- Passphrase
- File System
- Settings
- Selecting and configuring Secure Remote Services delivery
- Installation Troubleshooting
- Add Storage Capacity
PowerProtect DD6400 System Installation and Storage Expansion Guide
Installing and locking the front bezel
Prerequisites
CAUTION:Remove the protective plastic strip from the front of the bezel before you install the bezel. Failure to remove this strip will cause the system to overheat.
About this task
NOTE:If the rack is equipped with a door on the front, the shelf ships with an EMI shield instead of a bezel.
Steps
- Align the bezel with the shelf.
- Gently push the bezel into place until it latches.
- Secure the bezel by turning the key in the lock.
Figure 1. Installing the front bezel 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\