- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Accepting the End User License Agreement
- Run the configuration wizard
- Using the system configuration wizard
- License
- Network
- Passphrase
- File System
- Settings
- Selecting and configuring Secure Remote Services delivery
- Installation Troubleshooting
- Add Storage Capacity
PowerProtect DD6400 System Installation and Storage Expansion Guide
Install an ES40 shelf into the rack
Follow the steps in this section to install the rails, ES40 expansion shelf, and bezel. Follow these steps for each ES40 shelf you are installing.
There are no specific placement requirements for the ES40 shelves in relation to the DD6400 controller in the rack, as long as they are close enough to be connected by cables no longer than five meters.
NOTE:The included cables are one meter. Three and five meter cables are optional lengths.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\