- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Accepting the End User License Agreement
- Run the configuration wizard
- Using the system configuration wizard
- License
- Network
- Passphrase
- File System
- Settings
- Selecting and configuring Secure Remote Services delivery
- Installation Troubleshooting
- Add Storage Capacity
PowerProtect DD6400 System Installation and Storage Expansion Guide
DD6400 with ES40 cabling
The DD6400 system supports a maximum of two ES40 shelves. The diagrams show a single shelf, and two shelves cabled in a single loop.
| String (Loop) | I/O - Port | Shelf Port | Length 1 |
|---|---|---|---|
| 1 | I/O 3 - Port 0 | LCC B, port A of the shelf | 3M |
| 1 | I/O 3 - Port 1 | LCC A, port A of the shelf | 3M |
| String (Loop) | I/O - Port | Shelf Port | Length 2 |
|---|---|---|---|
| 1 | I/O 3 - Port 0 | LCC B, port A of shelf V1.2 | 3M |
| 1 | I/O 3 - Port 1 | LCC A, port A of shelf V1.1 | 3M |
| String (Loop) | I/O - Port | Shelf Port | Length 3 |
|---|---|---|---|
| 1 | LCC A, port B of shelf V1.1 | LCC A, port A of shelf V1.2 | 1M |
| 1 | LCC B, port A of shelf V1.1 | LCC B, port B of shelf V1.2 | 1M |
1 Cable lengths shown are designed for Dell EMC racks. Longer cables (up to 5M) can be used.
2 Cable lengths shown are designed for Dell EMC racks. Longer cables (up to 5M) can be used.
3 Cable lengths shown are designed for Dell EMC racks. Longer cables (up to 5M) can be used.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\