- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Accepting the End User License Agreement
- Run the configuration wizard
- Using the system configuration wizard
- License
- Network
- Passphrase
- File System
- Settings
- Selecting and configuring Secure Remote Services delivery
- Installation Troubleshooting
- Add Storage Capacity
PowerProtect DD6400 System Installation and Storage Expansion Guide
Connecting ES40 shelves
The cabling diagrams in this section show maximum configurations. Not all systems will have all the disk shelves shown in the diagrams.
When connecting ES40 shelves, all the cables have HD-mini-SAS connectors at both ends.
Add shelf-to-shelf cables between shelves in a loop and to the controller as shown in the diagrams.
CAUTION:When connecting SAS cables to the SAS cards, ensure there is sufficient slack in the cable to avoid unnecessary strain on the cable connector and the SAS card when the controller is fully extended from the rack.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\